Lighting
Interior, recessed, outdoor and security lighting, installed and repaired.
Last updated
Lighting is the cheapest change that makes a house feel different. We install recessed lighting, replace fixtures, run outdoor and landscape circuits, and mount ceiling fans.
For security lighting we will talk through placement and motion coverage before drilling anything, because badly placed floodlights mostly annoy the neighbors.
Lighting calls in Durango run out of our 178 Bodo Dr, Suite C office. We cover Durango, Bayfield, Ignacio, Hesperus, Mancos, Vallecito and the rest of La Plata County, and the Durango crew is on call 24 hours a day.
Recessed lighting, and the part that goes wrong
Recessed lights are chosen for how little they intrude and are then installed with too little thought for spacing, which is what makes a room look patchy. The usual rule of thumb is to space them about half the ceiling height apart, and to keep them far enough off the walls that they light the room rather than the paint.
The housing matters as much as the fixture. A housing in a ceiling with insulation above it has to be IC-rated, meaning it is built to be covered; one that is not has to be kept clear of insulation, which is difficult to guarantee and easy to get wrong during a later attic job.
In an existing ceiling, slim retrofit fixtures that fit a shallow box have made a job that once meant cutting into joists into one that usually does not.
Why new LEDs flicker on an old dimmer
Almost every flicker complaint after an LED change comes down to the dimmer. Old dimmers were built for the steady, heavy load of an incandescent filament, and they expect a minimum load to behave. An LED draws a fraction of that, so the dimmer sees almost nothing and becomes unstable — flicker, buzz, a narrow usable range, or lamps that glow faintly when switched off.
The fix is a dimmer designed for LED loads and lamps marked dimmable, matched to each other. Manufacturers publish compatibility lists for exactly this reason.
A faint glow from LEDs that are switched off is usually a switched neutral or a small leakage current through an electronic switch, not a fault in the lamps, and it has a proper fix rather than a workaround.
Color temperature, and why the same bulb looks wrong in two rooms
Color temperature is measured in kelvin, and the numbers are more intuitive than they sound. Around 2700K is the warm yellow of an old incandescent and suits living rooms and bedrooms. 3000K is slightly cleaner and is common in kitchens and baths. 4000K reads as neutral white and works in laundries, garages and workshops. 5000K and above is daylight, excellent for a shop and harsh in a lounge.
The usual mistake is mixing temperatures in one open space, which the eye notices immediately even when nobody can say why. Matching them within a room, and keeping adjacent rooms within a step of each other, does more for how a house feels than the fixtures do.
Brightness is lumens, not watts. An old 60W bulb is roughly 800 lumens, which is the number worth matching when replacing it.
Outdoor and security lighting that works
Security lighting fails in two directions. Too little and it lights nothing useful; too much, aimed badly, and it creates glare that blinds a camera and deep shadow next to it, which is better cover than darkness was.
Aiming low and wide, at the ground and the approaches rather than outward at eye level, is what makes a space feel lit and keeps the light on your own property. Motion sensors want placement where someone crosses the detection pattern rather than walks straight at it, which is where most of them are mounted.
Outdoors, fixtures, boxes and covers need to be rated for wet locations, and exterior receptacles need in-use covers and GFCI protection. Sun and blowing dust shorten the life of anything out here that was specified for a milder climate.
Ceiling fans, and the box behind them
A ceiling fan cannot hang from an ordinary lighting box. A fan moves, and that movement works on its fixing; it needs a box listed and marked for fan support, fastened to structure rather than to the ceiling material.
This is the single most common thing found wrong with a fan that was installed by somebody confident. It holds for a while, which is what makes it convincing.
Blade height and sweep matter for how a fan actually feels: too close to the ceiling and it moves little air, too low and it is in the way.
Emergency and exit lighting
Exit signs and emergency egress lighting are a large part of what we do for commercial buildings, and they are the fittings most likely to fail quietly: the head still looks right while the battery behind it no longer holds a charge long enough to matter.
We install them, test them, and replace the units and batteries that no longer hold up — which is also the part an inspector asks to see evidence of.
Shop, garage and task lighting
A garage or shop lit by one bulb in the middle produces a shadow exactly where you are working, because you are standing between the light and the work. Rows of linear fixtures running the same direction as the bench, or across the bay rather than along it, remove that.
Cooler temperatures around 4000K to 5000K read as sharper for detail work. Under-cabinet lighting does the same thing in a kitchen, where the wall cabinets put the counter in shadow all day.
What this covers
- Recessed lighting
- Fixture installation and repair
- Outdoor and landscape lighting
- Security lighting
- Ceiling fans
- Shop and garage lighting

Towns we cover from Durango
Questions
Lighting in Durango
Why do my LED lights flicker?
Usually the dimmer. Older dimmers were designed for the heavy, steady load of an incandescent bulb and need a minimum load to stay stable; an LED draws far less, so the dimmer behaves erratically — flicker, buzz, a narrow range, or a faint glow when off. An LED-rated dimmer matched with dimmable lamps resolves it.
What color temperature should I use?
About 2700K for living rooms and bedrooms, where it reads as the warm light of an old incandescent. 3000K for kitchens and bathrooms. 4000K for laundries, garages and workshops. 5000K and up is daylight, good in a shop and harsh in a lounge. The thing to avoid is mixing temperatures within one open space.
How far apart should recessed lights be?
A common starting point is to space them roughly half the ceiling height apart — about four feet apart on an eight-foot ceiling — and to hold them far enough off the walls to light the room rather than the paint. Layout depends on the room and on what the light is for, so it is worth planning before anything is cut.
Can I hang a ceiling fan from my existing light box?
Only if that box is listed and marked for fan support and is fastened to structure. A standard lighting box is not built for the movement and weight of a fan. This is the most common fault found on fans installed without the box being changed, and it holds for long enough to seem fine.
Why do my LED bulbs glow faintly when switched off?
Usually a small leakage current reaching the lamps — commonly from an electronic or illuminated switch, or from a switched neutral arrangement. The lamps are not faulty and it is not dangerous, but it does have a proper fix rather than something to live with.
What lighting work do you do beyond swapping a fixture?
Energy-saving retrofits, new lighting where a space is too dim and dimming where it is too bright, and emergency and exit lighting — which is a large part of what we do for commercial buildings.
Need lighting in Durango?
Most repairs are finished on the first visit. Emergency crews run 24/7 across the Four Corners.
